Engine storage ①Drain the cooling water in the engine. […]
①Drain the cooling water in the engine.
② Change the engine oil. New oils are usually neutral and do not corrode the engine's metal parts.
③ Fill the fuel tank with diesel to prevent the fuel tank from rusting. If conditions permit, preservatives should be added.
④ During the shutdown period, the engine should be started once a month to make the machine travel a short distance, and a new oil film should be established at the lubrication place of each part to prevent rust. It should be noted that the cooling water should be filled before starting, and the cooling water should be exhausted at the end.
Storage of batteries.
① The battery should be removed and placed in a dry and frost-proof place. To keep the surface clean and dry, do not place conductive objects on the battery. When removing the battery, first cut the negative wire, and then cut the positive wire; when installing, connect the positive wire first, and then the negative wire. Because the mechanical and electrical systems of the engineering band saw machine are grounded negatively, this is to prevent short circuit when disassembling and installing the battery.
② Lead-acid batteries should be charged once a month.
① Before storage, the size of the rust-proof paint on the outer surface should be determined according to the size of the peeling off area of the paint to repair the paint.
② The working device of the engineering band saw machine, such as the screed of the paver, the bucket of the loader, the scraper of the grader, etc., the anti-rust method of bare metal parts is to apply butter.