Introduce us to the content of the wood drying equipment that needs to be checked when entering the kiln, and I hope to help you. The floor and the floor of the drying room should be kept clean and tidy, and the sundries should be cleaned in time after a cycle of drying. Ventilation system, check whether the fastening bolts are loose, whether the fan works smoothly and freely, and whether the gap between the blades and the air collecting hood is uniform.
Whether the bearings of the motor and other parts are worn, whether the grease is lost, whether the cables are aging, etc. Shell, the key is to check the thermal insulation and air tightness of the shell.
The door, after the door has been used for a long time, air leakage may occur due to deformation, corrosion, aging of the seal or failure of the compression equipment. If such a situation is found, it should be repaired in time. On the outside, check whether the water in the water tank of the wet and dry bulb thermometer is clean, whether the gauze is clean and moist, and regularly calibrate the temperature sensor and moisture content sensor and appearance to check its sensitivity and reliability.
wooddryingkiln.com
English
简体中文
España