Large wood drying equipment system

The large-scale wood drying equipment system adopts energy-saving and environmentally friendly air energy heat pump heat source. The heat source part of the wood drying equipment is a high temperature air energy heat pump. The heat pump main engine configured according to the kiln type loading capacity (deploy) absorbs the heat in the air under the work of the compressor, compresses and vaporizes it into a high temperature medium of 95-105 ° C, and uses (meaning: open letters or public documents) insulation copper pipes are transported to the The heat exchange in the condenser (category: heat exchange equipment) in the kiln heats the air in the kiln, and the average energy saving efficiency reaches 2.78 (1KW of electric energy does work to absorb the heat in the air, which can generate 2.78 times the heating capacity of about 2400 kcal) ;Compared with the drying kiln shell with high thermal insulation effect and the equipment structure design and reasonable drying process, the comprehensive effect can save 22-33% of the energy consumption of the whole drying process compared with other conventional heat sources. The air energy heat pump is an energy-saving and environmentally friendly product advocated, with no waste gas and pollution. The supporting auxiliary electric heating system can configure the heat source for drying equipment with a drying temperature below 78 °C in the wood drying industry, especially suitable for an average climate temperature of 15 °C. The use in the above areas is also more suitable for areas with high environmental protection requirements and customers who pay attention to energy saving needs. Equipped with fan coil unit, it has obvious energy saving effect in wood constant temperature health preservation and paint baking room, and it is convenient and safe to use.
Equipment composition: energy saving and environmental protection air energy (other name: air source, air source water heater) heat pump heat source wood drying equipment consists of air energy heat pump host, thermal insulation copper (chemical Cu) tube, kiln exchanger, stainless steel (stainless acid-resistant steel) ) (brick-concrete) structure kiln body, kiln door (lifting door device), humidity control system, air circulation system, air intake and exhaust system, electric auxiliary system, detection system and control system.
Equipment principle: use clean power to drive the compressor (compressor) to absorb and transport the free heat in the air for heating, without manual operation and combustion to obtain heat; it is the most energy-saving wood drying equipment on the market. After using 1KW electric energy to absorb and transport the heat energy in the air, it will generate more than 3KW of heating energy; it will be converted into a high temperature medium (a decisive substance) of 95-105 ° C, and transported to the condenser in the kiln using an insulating copper (chemical formula Cu) pipe for exchange. The heat heats the air in the kiln to heat the wood, combining the advantages of conventional and dehumidifying drying, and supporting the critical drying process to dry the wood.

wooddryingkiln.com