Band saw machine chip removal device and maintenance

Chip removal device The belt saw is equipped with an air pump and a chip removal device with a tuyere. When the band saw is started, the air pump starts at the same time, and the compressed air blows the chips from the workpiece sawing through the tuyere to ensure the sawing goes smoothly.
Maintenance and safe use of the band saw machine (1) Before starting the machine, inject lubricant into each oil hole according to the instructions. (2) Before sawing, open the empty car for a few minutes and observe whether it is running normally. (3) Before sawing, check whether the band saw blade is moderately tight. Otherwise, not only will the quality of the sawing be affected, but the band saw blade may come out or break and cause an accident. (4) Before the band saw blade is trimmed, the grinding wheel should be idling for 3 to 5 minutes, the beating is observed, the wheel is trimmed, and then the band saw is repaired.

vertical band saw